Buy Magnetic Lock

- Jul 12, 2017 -

Magnetic lock design and the same as the electromagnet, is the use of the principle of electromagnetism, when the current through the silicon steel, the electromagnetic lock will have a strong suction tightly suction suction iron plate to achieve the effect of locking the door. As long as the small current electromagnetic lock will produce a great magnetic force, control the electromagnetic lock power access control system to identify the right after the power, the electromagnetic lock to lose suction to open the door. Because the electromagnetic lock is not complicated mechanical structure and the structure of the tongue, apply to the escape door or fire door access control. Its internal use of epoxy resin (epoxy) protection lock body. The current suction force of the electromagnetic lock is expressed in LB (pounds), the test method is static pressure. The so-called static pressure is the electromagnetic lock after the power gradually increased gradually to the adsorption of iron plate tension, when the suction force beyond the electromagnetic lock when the suction iron plate, the tension of the data is the electromagnetic lock of the tension value. And the force of the electromagnetic lock and the adsorbed iron plate must be face-to-face and is a linear linearized load, so that the holding force of the electromagnetic lock is the largest. Adsorption of iron due to a long time by the magnet magnetization of the magnet may be a temporary magnetization.

2 outside the door of the surface installation method

The first step: first with a screwdriver to open the cover, and then use the hexagonal wrench to beat the board, ready to install

Step 2: Take out the installation cardboard, fold the cardboard along the dotted line to place the cardboard in the desired locking position, and then punch the place where you need to punch it. The same time as the above-

The third step: A sub-iron plate fixed, the hexagon screw into the iron plate, the rubber factory set with two pieces of metal between the Division, and then set in the hexagonal screws. Will insert the iron plate into the door to play the three holes, while the mushroom head from the other side of the door into the use of hexagonal wrench will be locked in the door on the door. The same time as the above-

B side plate is fixed, the side plate with two semi-circular head screws fixed in the previously perforated door frame (fixed in the side plate of the long hole). Note: Do not lock the side panels so that they can be moved back and forth to facilitate the correction of the position.

The position of the side plate to correct the edge plate is suitable for the position of the side plate and the secondary plate, so that the lock main body can be brought into close contact with the iron plate. D lock the lock body and the side plate to lock the side plate of the semi-round head screws, then lock all the countersunk head screws, and then remove the semi-round head screws, drilling holes in the appropriate location for wiring. Finally, with a hex wrench lock the main lock on the side board. The same time as the above-

Step 4: Follow the instructions in the instructions wiring. The same time as the above-

Step 5: Cover the cover and insert the small aluminum cylinder into the screw hole of the main body.